How To Prepare Your Model Car For The Weather

You have just completed putting together your most recent model vehicle. It is a classic sedan from the 1950s, yet there is something about it that doesn’t feel quite right. It’s all brand new and glossy, and it seems completely out of place in the present. Ideally, you want it to seem as though it has just recently been pulled out of the weeds after having been sitting in someone’s yard for the previous forty years or so. What techniques do you use to get this level of realism in your model car? You could experiment with it by leaving it in the dirt and dust for a bit and seeing what occurs, or you could weather it yourself to see what happens. You can probably guess which would be the less difficult option.

Weathering A Model Automobile

A very easy operation that does not need the purchase of a large number of additional resources. All you need is some red and brown ink, a brush, and some water to complete this project. To finish humbrol paints your model automobile, just use your standard painting procedures. One thing you may want to consider is leaving certain areas of the design purposely thin. This will allow the corroded regions to be more easily distinguished. Aside from that, your model automobile should have a good even layer of paint applied to it. Following the drying of your ink, you may begin preparing your ink “rust.”

To make this ink, first mix ordinary ink in the color combination you choose, then blend it with water in a one-to-one ratio until the desired consistency is reached. As a result, you will get what is known as a wash. A wash will leave a small paint residue behind, but it will not cover up the base coat that is behind it. Make sure that the water and ink are thoroughly blended together. If the wash becomes split, you may end up with patches of thick paint on top of your undercoat, which may be extremely unsightly.

Once you’ve prepared the wash, you’ll be able to begin applying it. Paintbrushes should only be dipped very gently into the wash. Do not over-load your brush with the color since it might be difficult to regulate how much paint is left on your car once you have finished painting it with humbrol paints. Only the tip of your brush should be dipped in it; this will enable the remainder of the brush to pull part of the wash into the wash as well. Now softly brush the model automobile with the bristles of your brush. It should be placed in an area where you want the rust to begin to form.

Starting The Paint Job

Draw your brush away from this spot, which will give the impression that the rust is radiating from this location. It may make the difference between it appearing authentic and it seeming like a shoddy effort at putting artificial rust on a vehicle. Allow enough time for your wash to dry once you have applied it in this way. The amount of time it takes for the color to dry will be determined by how much color you have used. If you want to make the rust stand out even more, you may repeat the methods from the previous stage. Each time you do this, you will be adding a layer to the model automobile that it did not have before, making it seem older and older as time passes. In addition, the more you add, the more worn it seems to be. Make careful to use a variety of washes each time you wash. Rust does not have a consistent hue, and neither should your wash. With a little practice, you’ll be able to build your own antique model vehicles in no time.

Share:

Share on facebook
Facebook
Share on twitter
Twitter
Share on pinterest
Pinterest
Share on linkedin
LinkedIn

Leave a Comment

Your email address will not be published.

Social Media

Most Popular

Get The Latest Updates

Subscribe To Our Weekly Newsletter

No spam, notifications only about new products, updates.

Categories

On Key

Related Posts